There are three main aspects to evaluate plastic products. The first is the appearance quality, including integrity, color, gloss, etc; The second is the accuracy between size and relative position; The third is the physical, chemical, and electrical properties corresponding to the intended use. These quality requirements vary according to the different usage scenarios of the products, and the required scales also vary. The defects of the product mainly lie in the design, manufacturing accuracy, and wear degree of the mold. However, in fact, technicians in plastic processing plants often face difficulties in using technological means to compensate for mold defects without achieving significant results.

Adjusting the process during production is a necessary way to improve product quality and output. Due to the short injection molding cycle itself, if the process conditions are not well controlled, waste products will continue to flow. When adjusting the process, it is best to only change one condition at a time and observe it several times. If the pressure, temperature, and time are all adjusted together, it is easy to cause confusion and misunderstanding, and if there is a problem, it is unclear why. The measures and means of adjusting the process are multifaceted. For example, there are more than ten possible ways to solve the problem of product dissatisfaction. To truly solve the problem, it is necessary to choose one or two main solutions to solve the crux of the problem. In addition, attention should also be paid to the dialectical relationship in the solution. For example, if the product has a depression, sometimes the material temperature needs to be raised, and sometimes the material temperature needs to be lowered; Sometimes it is necessary to increase the amount of material, and sometimes it is necessary to reduce the amount of material. To acknowledge the feasibility of reverse measures in solving problems